Driven:
PCB Control
Filtration:
Single layer strainer
Cleaning:
Power Suction Head
Control:
Differential pressure & timer
Filtration Rating:
10 ~ 300 micron
Washing Time:
10 ~ 60 seconds
Pressure Lost:
Less than 0.018MPa
Max. Temperature:
95 degree C
Max. Pressure:
1.0 MPa
Housing Material:
Carbon steel with inner epoxy coating, SS 304, SS 316L, SS 2205
Filter Screen Material:
SS 304, SS 316L, SS 2205
Seal Material:
Graphite
Filtration Process
Water flows in from the inlet, fully fill in the internal of the filter screen and drain chamber while the drain valve is closed. Water starts going through the coarse filter screen from external to internal, then going through again the fine filter screen from internal to external. Filtered water flows out from outlet. During the Filtration Process, the inlet pressure become higher and higher while outlet pressure become lower and lower. When differential pressure between inlet and outlet has built up to 2 bar or the timer has achieved the setting time, the Cleaning Process will be started.
Cleaning Process
When the drain valves opens, foreign particles inside the filter screen and drain chamber will be flushed out through the drain valve. After few seconds, the motor starts kicking in through the speed reducer unit, the power suction start to turn into the filter screen, sucking the foreign particles in the internal part of the fine filter screen. During the cleaning process, the foreign particles sticking on the internal part of the fine filter screen will be flushed out through the drain valve.
Filtration Process Again
After 60 seconds of the cleaning process, the motor will stop, the drain will close and the filtration will resume its operation.
Reviews
There are no reviews yet.